This page defines the method I use for wax my snowboard and skis. The method makes usage of a warm gun, and does away with iron and scraping.It started with a collection of skis ns bought at a yard sale. I discovered the rate I got with them come be entirely unsatisfying, for this reason I made decision to look into waxing them. They to be an old pair that skis, so ns didn"t wantto salary for professional waxing.I didn"t have actually a perfect iron, not also one the those little travel irons. Therefore instead, i startedexperimenting with a heat gun to melt the wax on. A warmth gun is basically a high temperatureblow dryer. You can gain one indigenous a hardware store. Lock are commonly used because that stripping paint.Over time, I developed my technique, and likewise got into snowboarding. This page defines my existing technique,which i find really quick, so I do it every time ns go. It only takes a few minutes. Checking for and smoothing out scratchesI start by inspecting mine snowboard, to check out if there are any new scratches in it. I can"t removethe scratches, yet sometimes the scratches and gashes have actually burrs to them the stick up slightly. This probablyadd much more friction than the scratches themselves. So I usage a very sharp chisel or coffee to take turn off the burrs.Checking for residual wax
*
The next step is to check how much wax is left top top the plank - constantly interesting to check. This is straightforward to doby heater the board v a heat gun. Locations where wax is left will appear wet once heated. However it"s necessaryto understand when the plank is warm enough, even if there to be no wax left come melt. Therefore I constantly draw a couple of strokes top top theboard with the wax before using heat. Once these melt, I recognize I have enough heat. If nothing else appearsshiny approximately there, I know the wax is every gone.Applying the wax
*
The next step is to rub on wax. I perform this with the plank at room temperature. This way, I deserve to put on a really thin cloak of wax. I don"t desire to put so much wax on that I should scrape it turn off afterwards. This is the an essential to this technique.Heating the edges
*
On a snowboard, disproportionate quantities of wear are done to the edges. Therefore I always heat the wax top top the edgesfirst, and also make sure I have an even coat. I usually uncover that not the entire edge looks wet, so ns rubsome an ext on those parts, with the edge still warm.Melting the wax v cross strokes
*
The next step is come melt the wax in follow me the whole width the the board. I do this through doing cross strokeswith the hat gun. All along watching the reflected irradiate to make certain I am melt the wax.


You are watching: How to wax a snowboard without an iron


See more: How To Make Wood Planks In Minecraft, Wood Planks

I change the rate I go follow me to do sure whatever is melted in. The takes me about 30 seconds to cover the totality board.Buffing
*
After having actually melted the wax in, ns buff it through a item of file towel to do the result coat smoother.Inspecting
*