You are watching: How to restring a ryobi weed eater
Disconnect the spark plug for gas powered equipments by pulling the spark plug boot amethod from the back. Remove the battery or unplug an electrical machine.
Place the Weed Eater on the ground so that the cutting head is encountering upward.
A Ryobi Weed Eater is a line of string trimmers that use monofilament string for light duty trimming of grass or weeds. Replacing a line in a RyobiWeed Eater is easy sufficient that the operator can do it without a repair specialist.
Grasp the hub of the cutting head in one hand also. Place your various other hand on height of the spool retainer and also unscrew it. Ryobi manufactures some of their spool retainers to loosen counterclockwise and some to loosen clockwise. If the spool retainer seems to tighten when you revolve it counterclockwise, then automatically rotate it clockwise to loosen and rerelocate it.
Pull the spool away from the hub by grasping it around the edges and pulling it straight up. You will notice a spring attached to this spool. Leave the spring attached to the spool.
Grasp the hub of the cutting head in one hand also. Pull the spool away from the hub by grasping it around the edges and also pulling it straight up.
Rerelocate any kind of old line from the spool. With a clean towel, wipe ameans grass pposts and pollen from the spool, hub and also spool retainer.
Cut two pieces of monofilament line into nine-foot long pieces. Insert the initially line right into the anchor hole that is in the spool on the side closest to the spring. Wind the line in a counterclockwise direction about the top component of the spool. Leave a six- inch piece of line to trail and insert the line into the notch on the upper side of the spool.
Insert the second line into the anchor hole on the reduced side of the spool. Wind the line in a counterclockwise direction on the reduced side of the spool. Leave a six-inch trailing piece and also insert the line right into the second notch.
Remove any old line from the spool. Insert the second line right into the anchor hole on the lower side of the spool.
Turn the spool so that the spring points downward. Insert each trailing piece of line right into the eyelets in the side of the hub. Place the spool right into the hub with the spring bordering the shaft of the hub. Pull on the strings until they pull cost-free of the notches. Press the spool down and also rotate it counterclockwise till it snaps in area and will certainly no much longer revolve.
Screw the spool retainer ago onto the end of the hub. Pull the strings again to rotate the hub right into the cutting position. Reconnect the spark plug or plug in the battery or electrical cord.
Turn the spool so that the spring points downward. Screw the spool retainer back onto the finish of the hub.
Purchase replacement line made specifically by Ryobi. The agency color-codes their replacement line to make locating the appropriate dimension basic.
See more: Which Bones Articulate With The Femur, Which Bone Articulates With What
Acquisition replacement line made particularly by Ryobi. The agency color-codes their replacement line to make locating the right dimension straightforward.
Tracy Morris has been a freelance writer given that 2000. She has actually publimelted novels and countless virtual short articles. Her job-related has actually appeared in national magazines and newspapers including "Ferrets," "CatFancy," "Lexington Herald Leader" and "The Tulsa World." She holds a Bachelor of Arts in journalism from the College of Arkansas.